How to Replace the Starter in a 2008 Ford Escape Non-Hybrid 2.3L 4-Cylinder
If you own a 2008 Ford Escape non-hybrid with a 2.3-liter 4-cylinder engine, you may find it helpful to learn how to replace the starter. While there are no videos available on this specific starter replacement, I’ve put together a guide to help you through the process.
The starter is located in a challenging spot, making it difficult to access. It is situated above the transmission, between the radiator fan and the starter. To get started, you may need to remove the front clip to gain access to the starter.
Once the front clip is removed, you’ll be able to locate the starter and the bolts holding it in place. There are two bolts, one on top and one on the bottom of the bracket. Additionally, you’ll need to disconnect the oil pressure switch and three power wires to remove the starter.
When removing the starter, it’s essential to pay attention to the wire harness to avoid any complications. The ground wire is connected to the first bolt, and the oil pressure switch may need to be replaced due to potential brittleness.
After removing the old starter, you can install the new one in the reverse order. Once the new starter is in place, reconnect the oil pressure switch and power wires. After completing the installation, ensure that everything is properly secured and start the car to test the new starter.
It’s important to note that during the installation process, the wire harness may present challenges, and it’s advisable to take your time to avoid any issues.
If you have any questions or need further assistance, feel free to leave a comment. I hope this guide helps you with the starter replacement in your 2008 Ford Escape. Thank you for watching!