If you own a 2016 Ford Explorer and need to check your cabin air filter, it’s essential to follow the proper steps to access and inspect the filter, as demonstrated in this guide.
To begin, you’ll need to remove the glovebox door. Start by disconnecting the hinges located underneath the glovebox. There are white pieces that hold the bottom of the glovebox hinge together. Use a flathead screwdriver to pry and disconnect these white pieces on both sides. This will allow you to remove the glovebox completely.
Next, you’ll need to detach the damper by pulling it down, and then disconnect the stops that block the glovebox from coming out all the way. By pushing the stops up, you can release the glovebox. This step requires caution as the plastic components can be brittle and break easily.
Upon accessing the cabin air filter, use a flathead screwdriver to pry up the tabs holding the filter in place. Exercise care as the plastic can be delicate, and the tabs may break. Once the filter is removed, inspect its condition. If it’s dirty or in poor shape, it’s time to order a replacement. The video description includes a link to where you can purchase a new filter.
After acquiring the new filter, place it into the filter slot. Make sure to handle it with care to avoid damage. Once the new filter is installed, reattach the glovebox by hooking up the damper and sliding the hinges back into place. Ensure everything is secured before closing the glovebox.
By following these steps, you can successfully check and replace the cabin air filter in your 2016 Ford Explorer, ensuring that you and your passengers breathe clean, filtered air while on the road.
How do I check the cabin air filter in a Ford Explorer?
To check the cabin air filter in a Ford Explorer, you’ll need to remove the glovebox door. Start by disconnecting the hinges at the bottom of the glovebox by using a flathead screwdriver to release the white pieces holding them together. Then, disconnect the damper and push up the stops to allow the glovebox to come out. Once the glovebox is removed, locate the filter, which is located near the hinges. Use a flathead screwdriver to pry up the retaining tabs and remove the old filter. It’s important to be careful as the plastic tabs can be brittle. Check the filter for dirt and order a new one if needed. Finally, reinstall the glovebox door by reattaching the damper and sliding the hinges back on.