Are you interested in learning how to change the oil in your Jeep JLU with the four-cylinder gas engine? Look no further! In this article, we’ll guide you through the process step by step, including resetting the oil service light and properly installing the oil filter.
First, before you begin the oil change, start your vehicle and let the engine warm up. This ensures that the oil is warm, making it easier to drain and pick up any residue inside the engine.
Once the engine is warmed up, gather all your supplies, including an oil drain pan, socket set, oil filter, oil filter wrench, 5W30 full synthetic motor oil, and a creeper for easy access.
Next, remove the oil cap and drain the oil by removing the drain plug, using the appropriate socket size. Remember to keep tension on the threads while unscrewing the plug to prevent any spills.
After draining the oil, it’s time to remove the oil filter. Use a specialized tool to loosen the filter and let it drain before completely removing it. Clean the mating surface where the new filter will be installed.
Before installing the new oil filter, coat its gasket with clean oil and ensure the mating surface is clean. Then, gently thread the new filter into place and tighten it appropriately.
Once the oil filter and drain plug are secured, refill the engine with the recommended amount of oil. Make sure to use oil that meets the API SN plus requirements for your specific engine.
Finally, reset the oil service light by following the instructions in the vehicle’s manual. Don’t forget to check for leaks and properly dispose of the old oil and filter at a recycling center.
As an additional maintenance tip, consider combining oil changes with tire rotations to maximize tread life and ensure proper air pressure in the tires.
Remember, regular oil changes are crucial for engine health, so make sure to follow the recommended intervals for your vehicle. By performing this routine maintenance, you can keep your Jeep running smoothly for years to come.
For the products used in this tutorial, check out the links in the description below. And if you found this guide helpful, please consider using our affiliate links to support our channel at no extra cost to you.
Thank you for joining us in this oil change adventure, and we’ll see you next time!
What are some additions to the oil change video?
The additions to the video include how to reset the oil service light and how to properly put on the oil filter, including the number of turns to put it on once the gasket connects to the gasket base.
What is the first step in changing the oil?
The first step is to start the vehicle and let the engine warm up to ensure the oil drains easily and picks up any residue inside the engine.
What supplies are needed for an oil change?
The supplies needed include an oil drain pan, socket set, oil filter, oil filter wrench, synthetic motor oil, and a creeper to avoid working on the ground.
How is the oil drain plug removed?
The oil drain plug is removed using a socket wrench with the appropriately sized socket, and it should be unscrewed with some tension on the threads until it skips, allowing for clean removal.
Where is the oil filter located, and how is it changed?
The oil filter is located next to the oil pan on the driver’s side, and it is changed by using a tensioning device to unscrew it counterclockwise, wiping the mating surface, prepping the new filter with clean oil, and then securing it in place with the appropriate number of turns.
What type of oil is recommended for the Jeep JLU?
The recommended oil is 5W30 full synthetic motor oil with the API SN plus rating for the turbo engine.
How is the oil life reset in a Jeep JLU?
To reset the oil life, turn the ignition to the on run mode, go to the oil life Sub menu, and push and hold the OK button until the gauge resets to 100.
How should the old oil and oil filter be disposed of?
The old oil and oil filter should be taken to a local auto parts store for free recycling to avoid environmental damage.