If you own a Tesla Model 3 and want to perform a battery health test, accessing the service mode is essential. In this guide, we’ll walk you through the steps needed to access the service mode and conduct a battery health test for your Tesla Model 3.
To initiate the service mode, follow these steps:
- Tap the car icon located at the bottom left of the screen.
- Proceed to the “Service” section and hold down the car icon for the Model 3.
- When prompted for the access code, enter “service” and press enter.
- Select “enable” to enter the service mode.
Upon enabling the service mode, your car will automatically deactivate the AC, indicated by a red line around the screen. Next, navigate to the “Battery” section and click on “High Voltage”. You will then be able to view your battery health percentage.
When running the battery health test, ensure the charge is below 50%, the vehicle is plugged into a level-two charger, and be prepared for potential noise and heat generation during the discharge process.
After completing the test, check your Tesla app to verify if the car is still in service mode. The results of the battery health test should now be accessible.
Upon completing the test, it’s advisable not to leave your Tesla at 100% state of charge, unless equipped with the new LFP battery. It’s essential to discharge the battery to a lower percentage before extended periods of inactivity.
It’s important to cross-verify the results obtained from the battery health test with other apps like Tessie. Additionally, it’s recommended to avoid leaving the car at full charge post-test.
If you found this guide helpful, consider sharing it with other Tesla owners. Stay informed about your vehicle’s battery health and make informed decisions based on the test results.
Lastly, always prioritize safety and proper battery maintenance for your Tesla Model 3. Thank you for watching and stay tuned for more Tesla-related content.
Posted by: Your Name
Published on: Date
How do I access service mode on my Tesla?
To access service mode on your Tesla, follow these steps: 1. Tap the car icon located in the bottom left of the screen. 2. Navigate to the ‘Service’ section. 3. Hold down the car icon, select ‘Model Three’, and enter the access code ‘service’ before hitting enter. 4. Enable the service mode, which will result in the car turning off the AC and displaying a red line around the screen.
What is the process for conducting a battery health test?
To conduct a battery health test on a Tesla, follow these steps: 1. Access service mode. 2. Navigate to the ‘Battery’ section and select ‘High Voltage’. 3. Authorize the test by fully holding up on the turnstock and the brake, then follow the prompts. 4. Ensure the vehicle’s charge is below 50%, it is plugged in to a level two charging source, and be prepared for potential noise and heat generation during the test.
What should be done after completing the battery health test?
After completing the battery health test, it is important to avoid leaving the Tesla sitting at 100% state of charge unless equipped with the new LFP battery. Additionally, consider discharging the battery to a lower level before further use.
How to interpret the results of the battery health test?
Interpreting the results of the battery health test may require comparison with other metrics. It’s advisable to consult Tesla’s official documentation or seek advice from experienced Tesla owners to better understand the implications of the test results.