Many vehicles come equipped with the convenient HomeLink® system, which replaces up to three remote controls or handheld transmitters, allowing you to operate devices such as garage door openers, motorized gates, lighting, or home security systems from the safety of your driver’s seat.
The HomeLink® buttons are typically located in the overhead console or on the sun visor of your vehicle.
Programming for a Garage Door Opener
When programming your HomeLink® system for a garage door opener, it’s important to follow a few simple steps to ensure successful operation. First, make sure you are parked outside the garage and have new batteries in the handheld device you’ll be programming.
To reset the HomeLink® system memory, hold the two outside buttons until the indicator light flashes, which may take up to 20 seconds. This erases all three HomeLink® button programs, so you only need to do it once.
Determining the Type of Garage Door Opener
Before programming, you’ll need to determine the type of garage door opener you have. If your garage door opener has a LEARN or TRAIN button, you have a newer, “rolling code” garage door opener, which will require a few additional steps in the programming process. If there is no Learn or Train button, you have an older, non-rolling code garage door opener.
Programming the HomeLink® System
After determining the type of garage door opener, put the ignition switch in the On/Run position without starting the engine. Hold the handheld transmitter close to the HomeLink® system and simultaneously push and hold both the HomeLink® button you want to program and the handheld transmitter button. Follow the process to observe the indicator light, and test the programming by holding the just programmed HomeLink® button to check for completion.
Additional Steps for Rolling Code Garage Door Openers
If you have a rolling code garage door opener, after the initial programming steps, additional steps involving the garage door opener’s Learn or Train button will be necessary. These steps ensure synchronization between the HomeLink® controls and the garage door opener.
Final Notes
It’s important to note that HomeLink® will be disabled when an onboard security alarm is active. If any issues arise during programming, assistance can be obtained through the provided toll-free number or website.
For comprehensive details and essential safety information, always refer to your vehicle’s Owner’s Manual.
With these steps, you can effectively program your HomeLink® system to enhance the convenience and functionality of your vehicle.
What is HomeLink® system?
HomeLink® replaces up to three remote controls or handheld transmitters so you can operate devices such as garage door openers, motorized gates, lighting or home security systems from the safety of your driver’s seat.
Where can I find the HomeLink® buttons in my vehicle?
You’ll find the HomeLink® buttons in the overhead console or on the sun visor.
How do I reset the HomeLink® system memory?
To reset the HomeLink® system memory, simply push and hold the two outside buttons until the indicator light flashes, which could take up to 20 seconds.
What are the steps for programming the HomeLink® system for a garage door opener?
First, determine the type of garage door opener you have. Then, follow the specific programming steps based on whether it’s a newer rolling code garage door opener or an older non-rolling code opener.
What should I do if I have a rolling code garage door opener?
If you have a rolling code garage door opener, you will need to follow additional steps after programming the HomeLink® system button, including returning to the garage door opener to complete the training.
What should I do if I encounter problems with the HomeLink® system?
If you encounter problems or require assistance, please call toll-free 1-800-355-3515 or visit homelink.com for information or assistance.