P2111 Ford: Decoding and Troubleshooting the Throttle Actuator Control System

If you have a 2010 Ford Fusion and are facing trouble code P2111, here’s a simple solution to fix it. This code indicates an issue with the throttle actuator control (TAC). Fortunately, resolving this problem is relatively straightforward.

The electronic throttle body assembly is not available aftermarket, so you’ll need to get it from the dealership. To begin, you’ll need to disconnect the air duct and remove the four bolts holding the throttle body in place.

After replacing the throttle body, you’ll need to perform a recalibration. This process is simple and involves turning the car to the on position, slowly pressing the throttle all the way down, then slowly bringing it back up over a total of 10 seconds each way. Once this is done, turn the car off, and the recalibration is complete.

Upon restarting the car, you’ll likely find that the check engine light has turned off on its own, indicating a successful fix for the trouble code. The P2111 trouble code is a common issue with some newer Ford models, particularly the Fusion.

By following these steps, you can resolve the P2111 trouble code on your 2010 Ford Fusion and enjoy worry-free driving once again.

Thank you for reading!

What does trouble code P2111 indicate for a 2010 Ford Fusion?

The trouble code P2111 indicates an issue with the throttle actuator control (TAC), specifically related to the electronic throttle body assembly. This code is common in the 2010 Ford Fusion.

How do you replace the electronic throttle body on a 2010 Ford Fusion?

To replace the electronic throttle body on a 2010 Ford Fusion, you would need to disconnect the air duct, remove the four bolts that secure the assembly, replace it with a new throttle body, and then perform a recalibration.

How do you recalibrate the electronic throttle body on a 2010 Ford Fusion?

After replacing the throttle body, the recalibration process involves turning the car to the on position, slowly pressing the throttle all the way down for about 10 seconds, then slowly bringing it back up to the top. Finally, turning the key off to complete the recalibration.

What should be expected after replacing and recalibrating the electronic throttle body?

After replacing and recalibrating the electronic throttle body, the check engine light should turn off, and there should be no trouble codes in the system, indicating a successful replacement and calibration.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top