One of the essential maintenance tasks for your car is the replacement of its ignition switch. This tutorial will guide you through the step-by-step process of correctly and safely replacing your car’s ignition switch.
To begin with, the first task is to disconnect the negative battery terminal to ensure safety. After doing so, you need to remove the panel beneath the dashboard by unscrewing the bolts holding it. Next, slide out the panel carefully.
Then, tilt the steering wheel down to locate and remove the screws securing the steering column clamshell, allowing access to the ignition switch. Carefully disconnect the wiring and compare the old switch to the new one to confirm compatibility.
If needed, mark the new switch for alignment purposes before installing it. Connect the wiring, reassemble the components, reconnect the battery terminal, and ensure everything functions properly.
By following these steps, you can effectively replace the ignition switch in your car and ensure its optimal functioning for your safety and convenience on the road.
What is the first step to start the job?
The first step is to remove the negative battery terminal from the battery.
What panel needs to be removed under the dash?
There is a little panel that needs to be removed from the driver’s side under the dash.
What tools are needed to remove the steering column clam shell?
A small pocket screwdriver or a plastic trim tool can be used to remove the steering column clam shell.
How can the new ignition switch be aligned correctly?
The key should technically be in the reaward position, and a reference point can be marked to align the new ignition switch correctly.
What needs to be checked after installing the new ignition switch?
The key functions need to be checked to ensure proper functionality before proceeding further.