If you own a 2008 Ford Escape and need to replace the torque sensor, you’ve come to the right place. Follow these step-by-step instructions to successfully replace the torque sensor on your vehicle.
First things first, disconnect the battery to prevent the airbags from deploying or causing errors while you work on the steering column. Once the battery is disconnected, set the steering wheel to the 11 o’clock position and remove the steering column cover. This will allow you access to the torque sensor for replacement.
Remove the necessary bolts and disconnect the plugs, ensuring you label or video them for reference when reconnecting. Then, remove the old torque sensor, making sure to secure the steering wheel in place to prevent movement.
Using a T45 Torx bit, remove the required bolts to take out the steering column. You’ll also need a large snap ring plier to remove the snap ring and access the torque sensor cover. If the sensor is not aligned, adjust it accordingly before removing and replacing it with the new sensor.
Inspect the new sensor, use the alignment tool to ensure its correct position, and then insert it. Double-check the alignment and secure it in place with the clip. Reattach the snap ring and cover, ensuring everything is properly centered and aligned.
Once the new sensor is in place, reconnect the steering column, and reassemble the cover and connectors. Finally, reattach the steering wheel and reconnect the battery. It’s time for the moment of truth – turn on the car and test the power steering to ensure everything is working as it should.
If everything is functioning correctly, take the car for a test drive to ensure the sensor replacement was successful. With these steps, you can effectively replace the torque sensor on your 2008 Ford Escape, ensuring optimal steering performance.
What should I do before replacing the torque sensor on a Ford Escape 2008?
The first thing to do is to take out the battery and disconnect it. This is important because you’ll be working on the steering column and you do not want the airbags to deploy or set an error. Then, the steering wheel should be set to the 11 o’clock position before removing the steering column cover.
What tools are needed for removing the steering column cover?
You’ll need a 5.5mm bolt, a trim remover, and a 10mm socket to remove the casing for the steering column, including the panel.
What is used to remove the snap ring and cover of the steering column?
A very large snap ring plier is required to remove the snap ring and cover. A smaller one will not be sufficient.
What is the process for replacing the torque sensor?
After making sure the steering wheel is at the 11 o’clock position, use a T45 Torx bit to remove the sensor. Once the old sensor is out, the new one can be installed using the provided alignment tool and following the instructions. After confirming the correct position, put in the new sensor, double-check with the alignment tool, and secure it with a clip. Then, reattach the snap ring and cover.
What should be done after replacing the torque sensor?
After replacing the torque sensor, put the steering wheel back, ensuring all connectors are back in place. Test the car to ensure the power steering is functioning properly.