If you own a 2011 Hyundai Sonata, knowing how to change the oil is a fundamental skill that can save you time and money. This guide will take you through the process, step by step.
Tools you’ll need:
- Oil drain pan
- Paper towels
- New oil filter
- New oil
- 17mm wrench (for the oil drain plug)
- Jack stands
- Jack
Jacking up the Car
Locate the metal frame of the car to jack it up and place the jack stand to support it. Never jack up the frame components, as it won’t support the weight of the car.
Removing the Oil
Start by popping the hood and unscrewing the oil cap. Use a 17mm wrench to loosen the oil drain plug. Make sure to wear gloves and be cautious of warm oil. Remove the drain plug and let the oil drain into the pan.
Changing the Oil Filter
Remove the oil filter using an oil filter wrench. Let the remaining oil drain and then put on the new oil filter. It’s important to lubricate the new oil filter’s O-ring and tighten it by hand.
Adding New Oil
Refer to the owner’s manual for the correct oil type and amount. Use a funnel to add the new oil and check the level with a dipstick. Start the engine and recheck the oil level, topping up if necessary. It’s crucial not to overfill the oil.
Disposing of the Old Oil
Use the old oil container to transport the used oil to a recycling center or an auto parts store. Do not discard the old oil in the garbage.
By following these steps, you can successfully change the oil in your 2011 Hyundai Sonata, ensuring the optimal performance and longevity of your vehicle.
What tools are needed to change the oil on a 2011 Hyundai Sonata?
The tools needed to change the oil on a 2011 Hyundai Sonata include a oil drain pan, paper towels, new oil filter, new oil, 17 millimeter wrench, jack stands, jack, and a funnel.
Where is the recommended jacking point for the car?
The recommended jacking point for the car is the middle part of the car that’s reinforcing, not on frame components or suspension carriers.
What precautions should be taken while removing the oil drain plug?
Wear gloves while removing the oil drain plug to avoid getting oil on the skin. It’s also recommended to start the car for a couple of minutes if it’s cold to allow the oil to flow better, but be cautious of the oil temperature.
How should the new oil filter be installed?
After removing the old oil filter, apply a little bit of the old oil on the O-ring of the new oil filter to help create a seal. Hand-tighten the new oil filter and make sure it’s snug.
What is the recommended method for adding new oil?
Use a funnel to add the new oil. Check the owner’s manual for the specific type and amount of oil required for the car. Stop adding oil when it reaches the recommended level, and be cautious not to overfill.
How should the old oil be disposed?
Old oil should be taken to any auto parts store for recycling. Do not throw it in the garbage as it is bad for the environment.