When it comes to regular maintenance, changing the air filter is a crucial task for keeping your vehicle running smoothly. In this guide, we will walk you through the process of changing the air filter on a 2012 Honda Pilot with a 3.5-liter engine. Not only is this maintenance task important for the performance of your vehicle, but it’s also relatively simple to do.
Locating the Air Filter
To begin with, the air filter is located near the air intake tube that connects to the engine’s throttle body. There are four screws that hold the filter in place, and you will need a screwdriver or an 8mm socket to remove them. Once the screws are removed, you can take out the old air filter to inspect its condition.
Replacing the Air Filter
After removing the old filter, it’s time to install the new one. Make sure to position the new filter correctly, following the correct airflow direction indicated on the side of the filter. Once the new filter is in place, secure the air box by reattaching the screws, being careful not to over tighten them.
Checking the Cabin Filter
In addition to the air filter, it’s also essential to check the cabin filter for any debris or build-up. The cabin filter is usually located behind the glove compartment. You will need to remove the glove compartment to access and replace the cabin filter.
Installing the New Cabin Filter
When installing the new cabin filter, pay attention to the airflow direction indicated on the filter. Once the new filter is securely in place, reattach the glove compartment, and you’re all set.
Regular maintenance tasks like changing the air and cabin filters can greatly contribute to the longevity and performance of your vehicle. By following these simple steps, you can ensure that your 2012 Honda Pilot continues to run smoothly.
Where is the air filter located in a 2012 Honda Pilot?
The air filter is located near the air intake tube that runs into the engine’s throttle body. It can be accessed by unscrewing four screws that hold the filter in place.
How do you change the air filter in a 2012 Honda Pilot?
To change the air filter, unscrew the four screws holding it in place, remove the old filter, replace it with a new one, ensure it is oriented correctly, and then screw the air box back up tightly. It’s important to check for any disconnected electrical connectors or vacuum hoses that might affect the car’s performance.
How do you check and replace the cabin filter in a 2012 Honda Pilot?
To check and replace the cabin filter, empty the glove box, push the indicated tabs to rotate the glove compartment down, locate the filter, remove the old filter, insert the new filter in the correct airflow direction, lock it in place, rotate the glove compartment back up, and close it.