If you own a 2014 Honda Accord and are experiencing starter issues, don’t worry because you can change it yourself by following these simple steps. Before we begin, make sure to disconnect the battery as the starter wires are live all the time.
To access the starter, you’ll need to jack up the car or put it on car ramps to get underneath the vehicle. The starter is located near the oil drain plug, tucked up in the engine.
Once you locate the starter, you can proceed to remove it. It’s secured by two bolts and has wires attached for power and grounding. You’ll need basic tools like a socket wrench and a screwdriver to disconnect the wires and remove the starter.
When installing the new starter, make sure to connect the wires securely and position it properly before tightening the bolts. It’s important to take your time and be patient, especially when dealing with the top bolt.
After securing the new starter, remember to reconnect the battery, and then you can test the new starter by starting the car.
Changing the starter in your Honda Accord is a manageable task that can save you time and money. By following these steps, you can effectively replace the starter and get your car running smoothly again.
What is the first step to change the starter in a 2014 Honda Accord?
The first step is to disconnect the battery by removing the negative or positive cable to ensure there is no charge to the wires at the starter.
Where is the starter located in a 2014 Honda Accord?
The starter is located under the engine, near the oil drain plug. It is tucked up and may be obstructed by a bar, but can be accessed for replacement.
What precautions should be taken when working on the starter?
It is advised to ensure the car engine is cooled down to avoid burns from the hot exhaust pipe. Additionally, caution should be taken when removing and connecting the live wires to the starter.
What are the steps to install the new starter in a 2014 Honda Accord?
Once the old starter is removed, the new starter should be connected with its three plugs and secured with two bolts. After ensuring strong connections, the positive battery terminal should be reconnected to start the car.
What is the final step after installing the new starter?
The final step is to reconnect the positive battery terminal to allow the flow of current from the battery to the starter, enabling the car to start normally.