If you want to put an end to airborne contaminants in your car, then a new cabin filter from Filterheads.com can help you achieve cleaner air inside your vehicle.
The cabin filter is typically located on the left corner of the footwell. To replace it, follow these steps:
- Pinch the sides at the tabs and pull down to remove the securing tabs from their catch.
- Remove the bottom panel from the glovebox assembly.
- The filter housing cover has a screw on the bottom that requires a T20 Torx driver to remove.
- Pinch the tabs of the filter housing and pull outwards to remove it.
- Remove the old filter from the housing and clean out any debris inside.
- Install your new AQ1211 filter into the housing with its airflow indicating arrow pointing towards the back of the car. Ensure that the hard sides of the filter are on the top and bottom with the pleats vertical.
- Slide the housing cover into position and press to lock it into place.
- Reinstall the housing door screw.
- Reinstall the footwell panel by lining up the air duct openings and the two back tabs. Press up on the tabs to secure them on the screws.
By following these straightforward steps, you can effectively improve the air quality inside your car. To ensure that the new filter fits your specific car model, visit our website to order the right filter for your vehicle.
Where is the cabin filter located?
The cabin filter is located on the left corner of the footwell.
How do I remove the cabin filter?
Pinch the tabs and pull down to remove the securing tabs, then remove the bottom panel from the glovebox assembly. Next, remove the screw on the bottom of the filter housing cover using a T20 Torx driver. Pinch the tabs of the filter housing and pull outwards to remove it.
How do I install the new cabin filter?
Install the new filter into the housing with its airflow indicating arrow pointing towards the back of the car. Ensure the hard sides are on the top and bottom with the pleats vertical. Visit the website to order the filter to ensure it fits. Slide the housing cover into position and press to lock it into place. Reinstall the housing door screw and the footwell panel by lining up the air duct openings and back tabs, then press up on the tabs to secure them on the screws.