If you own a 2014-2018 Jeep Cherokee with the 2.4 cylinder engine, knowing how to reset the oil light is essential after an oil change. Here’s a step-by-step guide to help you do it yourself.
First, insert the key into the ignition and turn it to the run position without starting the engine. Allow the screen to start up. Then, using the directional pad on the speedometer, navigate to the oil reset light.
When you reach the oil reset light, it may display a message prompting you to hold the okay button to reset it. However, the actual process requires you to hold the okay button and simultaneously press the pedal down four times. Press the pedal down one, two, three, four times while holding the okay button. This action will reset the oil light, and you can then release the button.
After completing these steps, the oil light should reset, and the screen will display a message indicating 100% oil life. This confirms that you have successfully reset the oil light on your 2018 Jeep Cherokee.
It’s important to note that these instructions are specifically for the 2014-2018 Jeep Cherokees, and the process may not vary based on the engine type. However, it’s always best to refer to your vehicle’s manual for precise instructions.
How do you reset the oil light on a 2018 Jeep Cherokee?
To reset the oil light on a 2018 Jeep Cherokee with the 2.4 cylinder engine, follow these steps: – Put the key in the ignition and turn it to the run position without starting the engine. – Let the screen start up and then use the directional pad to go to the oil reset light. – Press and hold the ‘OK’ button and at the same time, press the pedal down four times. – Release the ‘OK’ button to reset the oil light. The screen should display ‘100%’ after the reset. Remember to subscribe for more tips and tutorials.