Are you having trouble resetting the Tire Pressure Monitoring System (TPMS) sensors in your car? Whether you drive a Chevrolet Cruze or another model, here’s a step-by-step guide on how to reset the TPMS sensors effortlessly.
To begin, follow these instructions:
- Start by getting inside the car, but do not put your foot on the gas pedal or start the car.
- Once inside, press and hold the “One” button for about five seconds to enter service mode.
- Use the arrow keys to navigate to the tire pressure option, and then press and hold the checkmark button to activate the tire learning mode.
- Your car will emit two beeps, indicating that the tire learning mode is now active.
If you find that letting air out of the tires does not reset the sensors, you can try using a Chevrolet model sensor resetter. This tool, which requires a 9-volt battery, can be easily purchased on platforms like Amazon.
Here’s how to use the sensor resetter:
- Locate the nozzle for air on each tire.
- Hold the sensor resetter above the nozzle, press and hold the button, and wait for a hum sound. Begin with the driver’s side front tire and continue in the specified order.
After resetting the sensors, check the Tire Pressure Monitoring System to ensure that signals are being received from all four tires. Once the system confirms the signals, you can turn off the car and start it up again.
It’s important to note that the order of the car’s lights can help determine the sequence for resetting the tires. Typically, the driver’s side front tire will be the starting point, followed by the passenger side front tire, passenger side rear tire, and finally, the driver’s side rear tire.
By following these steps, you can efficiently reset the TPMS sensors in your car and ensure that your tire pressure is accurately monitored.