If you own a 2017 1.5 liter four-cylinder EcoBoost Ford Fusion, it’s essential to know how to perform an oil change. In this step-by-step guide, I’ll walk you through the process and the tools you’ll need.
Tools Required:
- 13mm socket for the oil drain plug
- 10mm socket
- Oil filter wrench
- Motorcraft FL 910S oil filter
- Oil funnel
- Paper towels
- 3/8 drive ratchet
- Flathead screwdriver
- Impact driver (optional)
- 5w 20 motor oil
Step 1: Preparation
Apply the parking brake and lift the car using a sturdy jack or the car’s jack that comes with it.
Step 2: Remove the Splash Shield
Using a 10mm socket, remove the splash shield located under the car by unscrewing the clips.
Step 3: Drain the Oil
Locate the oil pan and use a 13mm socket to remove the drain bolt. Allow the old oil to drain into the oil drain pan.
Step 4: Remove the Oil Filter
Position the oil drain pan underneath the oil filter and use an oil filter wrench to remove the old oil filter. Clean the area before installing the new filter. Apply fresh oil on the seal of the new oil filter before installing it.
Step 5: Add New Oil
Add 4.3 quarts of 5w 20 motor oil to the engine. Check for any leaks and then reinstall the splash shield.
Step 6: Final Checks
Start the car to circulate the new oil and check for leaks. After running the engine, check the oil level using the dipstick and add more oil if necessary.
Reset the Oil Reminder
If your vehicle has an oil life reminder, follow the necessary steps to reset it.
With these simple steps, you’ve successfully changed the oil in your 2017 Ford Fusion EcoBoost. Regular oil changes are essential for maintaining the health of your engine. Thank you for reading!
What tools are needed for an oil change on a 2017 Ford Fusion?
The tools needed for an oil change on a 2017 Ford Fusion include a 13 millimeter socket for the oil drain plug, a 10 millimeter socket, an oil filter wrench, Motorcraft FL910S oil filter, oil funnel, paper towels, 3/8 drive ratchet, flathead screwdriver, impact driver, and 5w-20 motor oil.
What are the steps to change the oil in a 2017 Ford Fusion?
1. Apply the parking brake and lift the car on jack stands. 2. Remove the splash shield using a 10mm socket and flathead screwdriver. 3. Remove the oil drain plug. 4. Remove the oil filter and clean the area. 5. Install the new oil filter and replace the drain bolt. 6. Add 4.3 quarts of oil, check for leaks, and reinstall the splash shield. 7. Start the car and check the oil level, adding more if necessary.
How to reset the oil reminder on a 2017 Ford Fusion?
To reset the oil reminder on a 2017 Ford Fusion, go to the vehicle settings, then select ‘oil life reset’ when the remaining life is 0%. Press and hold ‘ok’ on the steering wheel to reset the reminder.