Jeep Wrangler Cabin Air Filter Replacement: A Step-by-Step Guide from Opening the Glove Box to Final Considerations

Welcome back to the blog! Today, we’re going to walk you through the process of replacing the cabin filter on a 2021 Jeep Wrangler Rubicon. This DIY tutorial is applicable to all Wrangler JLS and Jeep Gladiator models, so if you own one of these, keep reading to learn how to tackle this maintenance task.

1. Begin by Opening the Glove Box

After opening the glove box, you’ll notice a support arm. To release the glove box, pull the arm towards yourself and then push it upward to allow the box to come down, revealing the filter.

2. Access and Replace the Filter

Open the cap on the left side to access the cabin filter. Squeeze the indicated points to release the filter. Take out the old filter and compare it with the new one. The difference in air quality is evident, especially if the old filter has accumulated 20,000 miles’ worth of dirt and debris.

3. Install the New Filter

Ensure the arrows on the new filter are pointing downward and insert it properly. The two-piece filter design is demonstrated, and the ease of replacement is emphasized.

Final Thoughts and Considerations

It’s noted that the OEM Mopar filter is a single piece, prompting the poster to inquire about the possible change in design over Jeep model years. Furthermore, the recommendation to replace the filter sooner than the suggested 20,000 miles due to air quality concerns is highlighted.

Remember, maintaining the cabin filter is essential for the quality of air inside your vehicle, especially when using the AC and heater. Your health and that of your passengers should always be a priority when it comes to your vehicle.

If this tutorial was helpful for you, consider subscribing for more maintenance tips and tricks. Don’t forget to give this article a thumbs up if you found it useful. We’ll be back soon with more valuable insights. Until next time, drive safely!

What is the video about?

The video is about replacing the cabin filter on a 2021 Jeep Wrangler Rubicon, and the demonstration is applicable to all Wrangler JLS and Jeep Gladiator models. The video also discusses the importance of changing the cabin filter for better air quality inside the vehicle.

What products are used for the DIY?

The DIY uses the Mopar OEM cabin filter, which is shown and recommended for use in the video. The presenter also mentions that all the products used will be linked in the video’s description for purchase on Amazon.

How often should the cabin filter be replaced?

The cabin filter is recommended to be changed every 20,000 miles as per the Jeep guidelines, but the presenter suggests considering changing it earlier, such as at 15,000 or 12,000 miles, for better air quality and health, especially for children inside the vehicle.

What is the presenter’s observation about the cabin filter?

The presenter notes that the old cabin filter, after 20,000 miles, appears to be very dirty, indicating the accumulation of dust and particles. The presenter also shares a comparison of the old and new filters to emphasize the importance of replacing the filter for better air quality.

What is the observation regarding the Mopar filter?

The presenter discusses that the Mopar cabin filter bought at the local Jeep service department is a two-piece filter. There is a query regarding whether earlier models used two-piece filters and if the newer models utilize one-piece filters. The presenter shares a preference for the one-piece filter for future replacements.

What is the final message of the video?

The presenter concludes by emphasizing the importance of changing the cabin filter for better air quality, especially when using the AC and heater in the vehicle. The video ends with an invitation to the viewers to subscribe to the channel and like the video, with a promise of more content in the future.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top