If you are getting a PO369 error code, this article will provide you with two practical solutions to fix the error at home.
The PO369 error code means that the engine control module has detected that the engine camshaft position sensor circuit is not within specifications.
Method A: The Crankshaft Position Sensor
The crankshaft position sensor is most often located on the front underside of the engine, usually mounted to the timing cover.
Here are the steps to solve the problem:
- Remove the crankshaft position sensor from the vehicle and visually inspect it for any contamination.
- Conduct a resistance test on the sensor using a multimeter. Refer to your owner’s manual for the specific resistance range for your vehicle.
- If the sensor is faulty, replace it with a new crankshaft position sensor.
Method B: The Camshaft Position Sensor
The camshaft position sensor is located in the valve cover near the top of the engine or at the front or rear of the cylinder head.
Here are the steps to solve the problem:
- Remove the camshaft position sensor from the vehicle and visually inspect it for any contamination.
- Conduct a test on the sensor using a multimeter. Refer to your owner’s manual for the specific resistance range for your vehicle.
- If the sensor is faulty, replace it with a new camshaft position sensor.
Once you have completed the repairs, you can use the Zeus app to clear the error code and rescan your vehicle to ensure everything is fine.
What does the error code PO369 mean?
The error code PO369 means that the engine control module detected that the engine camshaft position sensor circuit is not within specifications.
What are the DIY methods to fix the PO369 error code?
There are two practical DIY solutions to fix the PO369 error code. Method A involves checking and, if necessary, replacing the crankshaft position sensor. Method B involves checking and, if necessary, replacing the camshaft position sensor.
How to fix the error using Method A (crankshaft position sensor)?
1. Carefully remove the crankshaft position sensor from the vehicle. 2. Visually inspect the sensor for contamination. 3. Use a multimeter to perform a resistance test. 4. Check the owner’s manual for the specific resistance range. 5. If the sensor is faulty, replace it with a new one.
How to fix the error using Method B (camshaft position sensor)?
1. Carefully remove the camshaft position sensor from the vehicle. 2. Visually inspect the sensor for contamination. 3. Use a multimeter to perform a test. 4. Check the owner’s manual for the specific resistance range. 5. If the sensor is faulty, replace it with a new one.
What should be done after fixing the error?
After fixing the error, use the Zeus app to clear the error code and then tap the rescan button to ensure everything is fine with your vehicle.