If you’ve been struggling with starting your Ford Escape by having to push the key in, you’re not alone. This is a common issue with the Ford Escape, and in this guide, I’ll show you how to fix it by replacing the ignition switch. This method is the proper fix for the problem and will ensure your car starts reliably without the need for any temporary hacks.
Before we begin, it’s crucial to disconnect the battery whenever working with electrical components or sensors to ensure safety.
Removing the Covers
Start by popping off the plastic covers located near the ignition switch. These covers are secured by clips and can be easily removed using a flat head tool.
Once the covers are off, you’ll have access to the screws that hold the lower cover in place. Use a 5.5mm tool to unscrew and remove the cover.
Replacing the Ignition Switch
After removing the covers, unplug the existing ignition switch by pressing the release tab and disconnecting the wiring harness.
Next, remove the old ignition switch by carefully disengaging the clips holding it in place. The new ignition switch can then be installed by aligning it correctly and securing it in place with the clips.
Testing the Fix
Once the new ignition switch is in place, reconnect the wiring harness and reassemble the covers. Reconnect the battery and test the ignition. You should no longer experience the need to push the key in for the car to start.
By following these simple steps, you can solve the Ford Escape ignition switch issue without the need for expensive professional help. This fix is cost-effective and can be completed within a short amount of time, saving you both time and money.
Remember to share this guide with anyone who might be experiencing similar issues with their Ford Escape. With this easy DIY solution, you can get your car back to starting smoothly in no time. Thanks for watching!
What is the issue with the Ford Escape that the video addresses?
The video addresses the issue where the Ford Escape won’t turn on and requires a key in a specific position to start.
What is the proper fix for the starting issue?
The proper fix for the starting issue is to replace the ignition switch.
What tools are needed for the ignition switch replacement?
You will need a flat head screwdriver and a 5.5mm size wrench or screwdriver to remove the cover and the screws.
Is it recommended to disconnect the battery before replacing the ignition switch?
Yes, it is recommended to disconnect the battery before replacing the ignition switch, especially when working with electrical components.
How long does it take to replace the ignition switch in a Ford Escape?
The video suggests that the ignition switch replacement can be done in under 20 minutes, making it a quick and easy job.