If you own a 2013 Honda Civic, changing the oil is an essential part of keeping your car running smoothly. Here’s a step-by-step guide on how to change the oil on a 2013 Honda Civic.
What You’ll Need
Before you start, make sure you have the following supplies ready:
- Jack
- Jack stands
- 17mm wrench
- Phillips screwdriver
- Oil (0W-20 Mobil One recommended by Honda)
- Oil filter with Honda gasket
- Funnel
- Oil pan
Getting Started
First, make sure the car is up on jack stands and the handbrake is engaged. Remember to put chalk behind the back wheels to ensure the car stays in place.
Removing the Skid Plate
Go underneath the car to locate the skid plate, which is held in place with Phillips screws. Remove the skid plate to access the oil pan and drain plug, as well as the oil filter. Place newspaper under the oil filter to prevent a mess.
Draining the Oil
Locate the drain plug and use a 17mm wrench to remove it. Also, remove the oil cap on top of the engine to help the oil drain faster. Ensure the oil pan is in position to catch the draining oil.
Replacing the Oil Filter
Twist off the old oil filter and let the remaining oil drain out. Before installing the new oil filter, apply a line of oil on the rubber gasket for a better seal. Screw on the new oil filter and tighten it by hand. Wipe off any spilled oil.
Refilling with Oil
Replace the drain plug with a new gasket, and tighten it with the 17mm wrench. Then, use a funnel to pour in the new oil as per the recommended quantity. Be attentive to spillage and cleanliness.
Finishing Up
Reattach the skid plate and lower the car. Finally, reset the car’s computer to complete the oil change process.
Conclusion
By following these steps, you can successfully change the oil on your 2013 Honda Civic and ensure your car’s engine runs smoothly.
What supplies do I need to change the oil on a 2013 Honda Civic?
You will need a jack, a 17 millimeter wrench, a Phillips screwdriver, jack stands, 0W-20 Mobil One oil (recommended by Honda), an oil filter with the Honda gasket, a funnel, an oil pan, and newspaper to prevent the area from getting dirty.
How do you access the oil pan and the oil filter?
First, remove the skid plate by unscrewing the Phillips screws. Once removed, you can access the oil pan and the oil filter. It’s important to use newspaper to prevent a messy work area.
How do you change the oil filter?
Before installing the new oil filter, line the rubber gasket with oil for a better seal. Simply screw the new filter in place and tighten it by hand. Then, wipe off any excess oil and check for leaks.
What do you do after changing the oil filter?
After changing the oil filter, reinstall the drain plug with a new gasket, then refill the engine with 0W-20 oil. Check the oil level and ensure there are no leaks. Properly dispose of the old oil at an appropriate recycling center.
How do you reset the computer after changing the oil?
To reset the computer after changing the oil, start the car and reset the computer using the car’s system. In this case, it involved pressing the middle button to reset the maintenance information, resulting in the oil life indicator showing 100%.