Today, we are going to walk you through the process of changing CVT fluid, specifically the HCF-2 fluid used on a CVT transmission.
First, locate the CVT fluid fill plug in the engine bay. It is typically a rubber plug labeled HCF-2. Remove this plug to access the filling point for the new fluid.
Next, go underneath the car to find the CVT fluid drain bolt and the check bolt. Use a 3/8 inch breaker bar to carefully undo the bolts. The drain bolt is 18 millimeters, while the check bolt is 12 millimeters.
Once the fluid has drained, install the drain bolt with a new crush washer and torque it to 36 foot-pounds. Now, it’s time to add the new CVT fluid using a long funnel to reach the fill hole. The amount of fluid needed may vary depending on whether the vehicle is all-wheel drive or not.
After adding the fluid, start the car and cycle through the gears, pausing for at least three seconds in each position. Then, turn off the car and repeat the process of adding fluid until it begins to drain out again.
By following these steps, you can successfully change the CVT fluid in your vehicle, promoting smooth transmission operation and longevity.
What type of fluid is used for CVT transmission?
The CVT fluid for HCF – – transmission is used.
Where is the CVT fluid fill plug located?
The CVT fluid fill plug is located in the engine bay, and it can be found below the oil filter.
What tools are needed to remove the CVT fluid drain bolt?
A 3/8 inch breaker bar is needed to remove the CVT fluid drain bolt.
How much fluid should be added for the CVT?
For all-wheel drive, four quarts of fluid are recommended. For non-all-wheel drive, three quarts are sufficient. The 12 millimeter check bolt should be removed while adding fluid, and if excess fluid is added, it will drain out of the check bolt.
What steps are involved in the CVT fluid change process?
1. Remove the drain bolt and drain the fluid. 2. Install the drain bolt with a new crush washer and torque it to 36 foot-pounds. 3. Add fluid through the CVT fluid fill plug using a long funnel. 4. Start the car, go through each gear, and then shut off the vehicle. 5. Repeat the process of adding fluid until it starts to drain out again.