In this video, we’re going to guide you through the process of replacing the water pump on a 2014 Chevy Malibu equipped with a 2.5-liter engine. So, let’s get started with the fix.
Step 1: Draining the Coolant
The first step is to raise the vehicle and put it on jack stands to access the underside and drain the coolant. You can locate the drain plug on the passenger side and proceed to drain the coolant into a container.
Step 2: Dismantling the Components
While the coolant is draining, dismantle the exhaust heat shield and the serpentine belt to access the water pump. It’s essential to take proper precautions to prevent any damage to the belt during the process.
Step 3: Removing the Water Pump
Remove the four bolts holding the water pump in place and carefully detach it from the engine. Take note of any seals or gaskets that may need replacement along with the water pump.
Step 4: Installing the New Water Pump
Before installing the new water pump, ensure that it matches the old one in terms of shape and pulley diameter. Place the new gasket in position and secure the water pump by tightening the four bolts in a crisscross pattern.
Step 5: Finalizing the Installation
Once the water pump is in place, reattach the serpentine belt, exhaust heat shield, and any other components that were removed. It’s crucial to clean any spilled coolant and ensure that all connections are secure before refilling the coolant and testing the vehicle.
Additional Tips
It’s recommended to use the manufacturer-recommended coolant for refilling, and taking care of small details like reconnecting the oxygen sensor after bleeding the coolant system can prevent potential issues.
Conclusion
Replacing a water pump on a 2014 Chevy Malibu with a 2.5-liter engine is a manageable task if approached with caution and attention to detail. By following the steps outlined in this guide, you can successfully complete this repair and ensure the proper functioning of your vehicle’s cooling system.
Remember, proper maintenance and timely replacements are crucial for the longevity of your vehicle. We hope this guide has been helpful to you. Thank you for watching!
What is the first step in replacing the water pump on a 2014 Chevy Malibu?
The first step is to raise the vehicle up, put it on jack stands, and then drain the coolant from the passenger side of the vehicle.
What tools are needed to remove the serpentine belt?
A half-inch ratchet end and a serpentine belt tool are needed to remove the serpentine belt. It’s recommended to use the right tools to avoid taking off the tire or plastic cover.
How many bolts need to be removed to replace the water pump?
There are four bolts that need to be removed to replace the water pump. The new water pump comes with a new gasket, and it’s important to inspect and ensure that it matches the old pump before installation.
What are the final steps after replacing the water pump?
After replacing the water pump, it’s important to tighten the bolts in a crisscross pattern, wipe down and clean the area, put the serpentine belt back on, and then proceed with the bleeding process for the coolant system. Additionally, it’s advised to use the manufacturer-recommended coolant for the vehicle.