In this blog post, we’re going to cover the step-by-step process of jumpstarting a 2015 Ford Escape. Whether you’re dealing with a dead battery or assisting someone else with jumpstarting their vehicle, it’s important to follow the correct procedure to ensure safety and effectiveness.
The first step is to locate the release lever for the hood on the left-hand side of the cabin, underneath the steering wheel. The second release lever is located under the hood on the left-hand side and is usually labeled in yellow. Once you release the hood, use the hood rod to prop it up. Ensure that the hood rod is properly slotted by an arrow at the top.
Next, locate and remove the battery cover on the top right-hand side of the engine column, almost underneath the windshield. This will expose the battery and allow you to access the terminals for jumpstarting.
When jumpstarting the Ford Escape, you will need to use the nut and bolt located near the battery to connect the jumper cables. Start by connecting the red cable to the red post on the battery, ensuring that it is securely attached. Then, connect the negative cable to the negative post on the right-hand side. Remember, it’s always red to red and black to black when jumpstarting a vehicle.
Once the cables are connected, double-check to ensure they are secure and properly attached. The red cable should be connected to the positive terminal, and the black cable to the negative terminal.
Following these steps will effectively jumpstart the 2015 Ford Escape. It’s important to always exercise caution and follow the correct procedure to avoid any potential risks. We hope this guide has been helpful in demonstrating how to jumpstart a Ford Escape. Thanks for reading!
How do you jumpstart the 2015 Ford Escape?
To jumpstart the 2015 Ford Escape, follow these steps: 1. Locate the release lever for the hood underneath the steering wheel and under the hood on the left-hand side, labeled in yellow. 2. Use the hood rod to prop up the hood properly. 3. Remove the battery cover on the top right-hand side of the engine column. 4. Connect the red cable to the red post on the battery and ensure it is secured. Then connect the negative cable to the negative post on the right-hand side.