Changing the oil on your car is an essential part of vehicle maintenance to ensure engine longevity and smooth operation.
If you own a 2017 or newer Jeep Compass with a 2.4-liter four-cylinder engine, this guide will show you how to change the oil and reset the oil light all by yourself.
Step 1: Prepare the Car
First, pop the hood of the car and make sure the engine is warm. You can run the car for about 10-15 minutes to warm up the oil and make it easier to drain.
Step 2: Drain the Oil
Place a drain pan under the car to catch the oil and locate the oil drain plug. Use a 13mm socket or wrench to loosen the drain plug and let the oil drain completely. Inspect the plug and replace the rubber sealing ring if necessary.
Step 3: Replace the Oil Filter
Remove the old oil filter, making sure to remove any old O-rings. Install a new filter, ensuring it’s properly lubricated, and tighten it securely.
Step 4: Refill the Oil
Remove the oil fill cap and add the recommended amount of oil. Check the oil level with a dipstick and top it up as necessary.
Step 5: Reset the Oil Light
If needed, reset the oil change light following the specific steps for your car model.
Step 6: Final Checks
After completing the oil change, double-check for any leaks, clean any spilled oil, and ensure the oil cap and dipstick are properly secured.
If you found this guide helpful, consider saving it for future reference, and perform regular oil changes to keep your Jeep Compass in top condition.
What type of oil does the 2017 Jeep Compass use?
The manual recommends using five and a half quarts of recommended zero W20 oil for a full oil change. It is important to use a synthetic oil and a quality oil filter if you run five or six thousand miles on an oil change.
What tools are needed to change the oil on a Jeep Compass?
For changing the oil on a Jeep Compass, you will need a drain pan, 13mm socket or wrench for the drain plug, a ratchet wrench, shallow socket with a ratchet, oil filter wrench, a torque wrench, and a funnel.
How do you reset the oil light on a Jeep Compass?
To reset the oil light on a Jeep Compass, turn the ignition on without pressing the brake, press the gas pedal to the floor and release it three times, then turn the ignition off.