If you have a Jeep Cherokee and need to replace the starter, don’t worry! It’s a relatively straightforward process that you can do yourself. Here’s a step-by-step guide to help you through the replacement.
First things first, safety is key. Start by disconnecting the negative battery terminal to prevent any arcing or sparking.
Once you’ve done that, you can locate the starter below the air filter, covered in grime and dirt. The starter is secured with bolts and wires that need to be disconnected.
There is a small wire and a larger one connected to the starter. Using a 5/16 socket, you can disconnect the smaller wire, then remove the larger one connected to the battery.
Next, you’ll need to loosen and remove the bolts holding the starter in place. These may require a swivel extension and some maneuvering to access.
Once the bolts are removed, you can carefully lower the starter and disconnect it from the car. Then, position the new starter in place and re-secure it with the bolts.
After tightening the bolts, re-connect the wires to the new starter and ensure they are snug but not over-tightened.
Finally, re-connect the negative battery terminal, and you’re all set. You’ve successfully replaced the starter in your Jeep Cherokee!
What is the first step to replace the starter on a Jeep Cherokee?
The first step is to disconnect the negative battery terminal to prevent arcing or sparking.
Where is the starter located in the Jeep Cherokee?
The starter is located beneath the air filter, covered in dirt and grease. It can be accessed from underneath the car.
What tools are needed to remove the starter?
To remove the starter, a quarter inch drive ratchet and socket (5/16), a half inch socket, and extensions for the ratchet are needed. A 15-sized bolt is also required.
What precautions should be taken when removing the starter wires?
When removing the starter wires, it’s important to avoid hanging the starter on the wires or pulling them and breaking them. Care should be taken to disconnect the wires without damaging them.
How should the starter bolts be tightened?
When tightening the starter bolts, both the bottom and top bolts should be snug before one is completely tightened. Avoid putting excessive torque on the bolts to prevent breakage.