Are you having issues with the starter in your 2012-2014 Toyota Camry with a 2.5 four-cylinder engine? Not to worry, in this guide, I’ll walk you through the process of replacing or removing the starter. Let’s get started!
To begin, you’ll need to remove the plastic cover held in place by clips. Use a flathead screwdriver to carefully take them out one by one.
It’s crucial to disconnect the negative battery cable before proceeding further to ensure safety.
Now, let’s tackle the air intake system. Remove the entire system by loosening the bolts and disconnecting the mass air flow sensor.
Once the air intake system is out of the way, you’ll have clear access to the starter. Disconnect the electrical plug and remove the rubber cap to reveal a 12mm nut that needs to be taken out. Slide the battery cable off the starter and proceed to remove the two 14mm bolts securing the starter in place.
With the starter removed, it’s time to install the replacement. Tighten the 14mm bolts to a torque of 27 pound feet. Reconnect the battery cable and plug in the electrical connector.
Reassemble the air intake system by reinstalling the lower and upper halves, ensuring all connections are secured. Finally, reattach the plastic cover and reconnect the battery.
Completing this task is relatively straightforward and requires only a few tools and a little bit of time. By following this guide, anybody can successfully replace or remove the starter in a 2012-2014 Toyota Camry.
What tools are needed to replace the starter on a 2012-2014 Toyota Camry with a 2.5 four-cylinder engine?
You will need a flathead screwdriver, ten millimeter and 14 millimeter socket wrenches, needle nose pliers, and a torque wrench.
What is the first step in replacing the starter?
The first step is to disconnect the negative battery cable.
What needs to be removed to access the starter?
The air intake system, including the plastic cover, airbox, intake tube, and airflow sensor, needs to be removed to access the starter.
What are the steps for removing the starter?
1. Disconnect the electrical plug from the starter. 2. Remove the rubber cap to access the 12 millimeter nut and slide off the battery cable. 3. Remove the two 14 millimeter bolts to take out the starter. 4. Replace with the new starter, tighten the bolts to 27 pound feet of torque, reconnect the battery cable and electrical connector.
Is any special expertise required to replace the starter on a 2012-2014 Toyota Camry with a 2.5 four-cylinder engine?
No, the task is relatively easy and can be done with the right tools and a few minutes of time.